Enquiry:
We would like to have a 3rd Party Testing on PU Foams for Test Standard as follows:
PU Foam Service temperature, the required standard is EN 253 (2019) section 4.5.6 and the requirement is the range of -50 degrees to 140 degrees Celsius
Awaits for your quotation please.
One of our highly proficient and ISO certified laboratory would be taking over this testing.
Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].
Enquiry:
I would like to inquire if the following fuel analysis can be performed in Lebanon? And what is the cost and time involved?
Lead Content ” ASTM D3237
Aliphatic (Saturates) * MID-IR
Aromatics, Total ” MID-IR
Benzene ” MID-IR
Ethanol * MID-IR
MTBE * MID-IR
Octane Number (MON) ” MID-IR
Octane Number (RON) * MID-IR
Olefins ” MID-IR
Oxygen * MID-IR
Appearance Visual
Color Visual
Density @ 15°C ASTM D4052
Initial Boiling Point IBP ASTM D86
10% Vol Recovery ASTM D86
50% Vol Recovery ASTM D86
90% Vol Recovery ASTM D86
Final Boiling Point FBP ASTM D86
Percent Recovery ASTM D86
Residue ASTM D86
Specific Gravity @ 15’C ASTM D4052
Vapor Pressure ASTM D6378
Water Content, Karl Fischer ASTM D6304
Your assistance would be highly appreciated.
One of our highly proficient and ISO certified laboratory would be taking over this testing.
Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].
Enquiry:
I would like to request for a budgetary quotation to carry out all test of transformer oil as per IEC 60422 as shown below
Kindly revert whether you are able to quote for this item.
One of our highly proficient and ISO certified laboratory would be taking over this testing.
Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].