• Home
  • Archive by category "Soil Test"

Plant Tissue, Water, and Soil Testing in KSA

Enquiry:

We have an ongoing project at KSA and we are looking for your best and competitive offer for the water & soil analysis report that includes the attached parameters.

  • Soil test report
  • Water test report
  • Plant tissue test report

Please don’t hesitate to contact us if you required further clarification/assistance for the same.

Your immediate response in this regard is highly appreciated.

 PARAMETERS REQUIRED IN SOIL TEST REPORT

  Parameters  Unit  Test method
pH  
Electrical Conductivity (EC)mS/cm 
Total Dissolve Salts (TDS)mg/L 
Total Nitrogen% 
Nitrate Nitrogen; NO3-Nppm 
Phosphorous (P)ppm 
Potassium (K)ppm 
Calcium (Ca) + Magnesium (Mg)ppm 
Sulphur (S)ppm 
Chloride (Cl-1)ppm 
Iron (Fe)ppm 
Zinc (Zn)ppm 
Copper (Cu)ppm 
Manganese (Mn)ppm 
Boron (B)ppm 
Organic Matter% 
SAR (Sodium Adsorption Ratio) 
CO3– –ppm 
HCO3– –ppm 
Na+ppm 
Soil Texture (Sand, Silt, Clay)% 
Soil Structure 
Soil profile analysis  
Soil properties and soil types  

PARAMETERS REQUIRED IN WATER TEST REPORT

  Parameters  Unit  Test method
pH  
Electrical Conductivity (EC)mS/cm 
Total Dissolve Salts (TDS)mg/L 
Nitrate Nitrogen; NO3-Nppm 
Potassium (K)ppm 
Calcium (Ca) + Magnesium (Mg)ppm 
Total Hardness  
Chloride (Cl-1)ppm 
CO3– –ppm 
HCO3– –ppm 
Na+ppm 

OPTIONAL

 PARAMETERS REQUIRED IN PLANT TISSUE TEST REPORT

  Parameters  Unit  Test method
Total Nitrogen% 
Phosphorous (P)ppm 
Potassium (K)ppm 
Calcium (Ca) +  Magnesium (Mg)ppm 
Sulphur (S)ppm 
Chloride (Cl-1)ppm 
Iron (Fe)ppm 
Zinc (Zn)ppm 
Copper (Cu)ppm 
Manganese (Mn)ppm 
Boron (B)ppm 

One of our highly proficient and ISO certified laboratory would be taking over this testing.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].

Soil, Mix Concrete, and Water Test in Saudi

Enquiry:

We start to build the dates factory and need your lab service to test the soil, mix concrete and water with following Parameters.

  1. Trial Test pit for Soil        
  2. Plate bearing (Dry condition) (ASTM) 2-test
  3. Attain the trial mix + Air content + Slump test + Temperature + Unit weight.
  4. Setting time of concrete (Initial and Final)
  5. ISAT
  6. RCP (ASTM)
  7. Water Absorption – Hardened concrete
  8. Water Permeably (BS EN)

Please send your best possible offer for the above.


One of our highly proficient and ISO certified laboratory would be taking over this testing.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].