• Home
  • 2026
  • October
  • 22

3rd Party Inspection Certificate Oil Tanks in Musaffah, AD, UAE

Enquiry:

We have oil tanks (3 nos approx. 5 M3   each one) located at our facility in Musaffah Abu Dhabi.

We require a third-party safety inspection certificate for the same. Could you please share your procedure and quotation for this inspection?


One of our highly proficient and ISO certified laboratory would be taking over this job.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].

Nutritional Panel and Low GI Testing in Rice, Karachi, Pakistan

Enquiry:

Nutritional Panel and Low GI Testing

We require nutritional analysis for our rice products to comply with US FDA nutritional labelling requirements. Please find the required test parameters below:

  1. Moisture and ash
  2. Protein by the Kjeldahl method, using the nitrogen conversion factor of N × 5.95 for rice
  3. Total fat
  4. Fatty acid profile: saturated, trans, monounsaturated, and polyunsaturated fats
  5. Dietary fiber
  6. Total sugars
  7. Carbohydrates (calculated by difference)
  8. Energy value, calculated and reported in both kcal and kJ
  9. Sodium, potassium, calcium, and iron
  10. Cholesterol
  11. Vitamin D

We require the results to be reported on both a per 100 g and per 45 g serving basis. Carbohydrates and energy may be calculated where appropriate, based on the analytical results.

Kindly provide your quotation for the above parameters, including any discounted rates for multiple rice samples. Please also confirm the turnaround time, sample quantity requirements, and whether you can prepare the Nutrition Facts panel in accordance with US FDA requirements.


One of our highly proficient and ISO certified laboratory would be taking over this job.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].

Settled Sludge Sample Testing in Jubail, KSA

Enquiry:

Our company invites your laboratory to submit a technical and commercial proposal for the analysis of a bottom settled sludge sample collected from POND-I at our facility.

The objective of this study is to fully characterize the sludge composition and determine the purity and percentage of Sodium Sulphate (Na₂SO₄) through a two-stage analysis, including:

  • Full characterization of liquid and solid phases
  • Hydrocarbon, BTX, VOC, TOC, COD, pH, metals, and metal salts analysis
  • Advanced pretreatment to remove water and hydrocarbons
  • Dry mineral matrix analysis for Sodium Sulphate quantification
  • Complete mass balance calculations and Certificate of Analysis (COA)

Please find the attached Scope of Work for your review.

Kindly confirm your laboratory’s capability to perform the required separation, pretreatment, and analytical procedures, and provide the following:

  • Technical proposal and methodology
  • Accreditation details (ISO 17025 or equivalent)
  • Estimated turnaround time
  • Commercial quotation
  • Sample quantity requirements, if any

We would appreciate receiving your quotation at most of your convenience time.

KINDLY ACKNOWLEDGE RECEIPT OF THIS EMAIL BY A REPLY

Should you require any clarification, please feel free to contact the undersigned.


One of our highly proficient and ISO certified laboratory would be taking over this job.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].