• Home
  • 2026
  • September
  • 30

Transformer Oil Testing in France, Europe

Enquiry:

More in details, they are 3Φ 12.4MVA 33,000V – 4 x 1,850V 50Hz 24-Pluse transformers.

Following a transit incident, we would like to perform following test on them :

These tests need to happen in Dubai or not far away, and in an independent test lab which does not manufacture transformers itself.

Is this something that you would be able to help with ?


One of our highly proficient and ISO certified laboratory would be taking over this job.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].

Hydrostatic Pressure Test, Certification of LPG Tank in UAE

Enquiry:

We kindly request you to submit your quotation for the Hydrostatic Pressure Test and certification of our LPG tank.

Should a site visit be required prior to issuing the quotation, please coordinate with Mr. _______________ for the necessary arrangements.


One of our highly proficient and ISO certified laboratory would be taking over this job.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].

Hydraulic Oil Testing in Malaysia

Enquiry:

We are writing to invite your company to submit a quotation for hydraulic oil analysis services.

Company: Sdn Bhd, Lot 16, Jalan Sementa 27/91, Seksyen 27, 40400 Shah Alam, Selangor

Requirement: We require laboratory analysis for 18 used hydraulic oil samples taken from our die-casting machines, plus 1 new/fresh oil sample for comparison purposes.

Objective: To evaluate oil condition, contamination level, and hydraulic system/component wear as part of our preventive and predictive maintenance programme.

Minimum Required Tests:

  1. Kinematic Viscosity @ 40°C
  2. ISO 4406 Particle Count / Cleanliness Level
  3. Water Content (Karl Fischer method), ppm
  4. Total Acid Number (TAN)
  5. ICP Elemental Analysis (including Fe, Cu, Al, Cr, Ni, Si, Na, Ca, Zn and P)
  6. FTIR / Oxidation Analysis
  7. PQ Index / Ferrous Density (if available)

Report Requirements:

  • Complete laboratory test report with results and units
  • Acceptable/normal limit, caution limit and critical limit (where applicable)
  • Technical comments and recommendations for any abnormal findings

Additional Information Needed in Your Quotation:

  • Unit price and total price for 18 samples (+ 1 new oil sample)
  • Turnaround time (standard and urgent options, if any)
  • Sample volume required per sample
  • Whether sample collection from our Shah Alam factory is available
  • Validity period of quotation
  • Any accreditation (e.g. ISO 17025) relevant to the tests

Important – Supplier Registration Requirement:

Please note that the official RFQ will be floated through the _____________ on 2 October 2026.

If your company is not yet registered as a supplier under _________ Active Vendor List, you must complete the supplier registration process before participating in the RFQ in the Zycus system.

The registration guideline is attached for your reference. Kindly complete the registration at your earliest convenience and inform us once done.

We look forward to receiving your quotation and confirmation of registration status.


One of our highly proficient and ISO certified laboratory would be taking over this job.

Should you have any similar requisites, do drop us email and we shall revert instantly -> [email protected].